Preparing Connection Areas Of The Body For Installing Rear Trunk Floor Panel
WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tool s necessary for later repair work are available.
- Align the sealing surface and connections of the body.
- De-burr connection points and prepare them for joining.
- Prepare the marked areas > Joint areas
for joining.
>5X00IN WORKING WITH BODY STRUCTURAL ADHESIVE
Joint areas
- Prepare the marked areas > Joint areas
for joining.
>5X00IN WORKING WITH BODY STRUCTURAL ADHESIVE
Joint areas