Preparing (Inner Part Of) Longitudinal Member For Wheel Housing Upper Section

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fit in (inner part of) longitudinal member for wheel housing upper section and secure it to the body.
Drill holes for blind rivets -A- . > Diameter 6.6 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Holes for blind rivets
Punch hole for flow-form rivets -B - using > VAS 852 001 - dent removal unit and > VAS 6790 - compact booster .
>5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Hole for flow-form rivets
Remove (inner part of) longitudinal member for wheel housing upper section.
Prepare (inner part of) longitudinal member for wheel housing upper section for riveting and bonding.
>5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Longitudinal member for wheel housing upper section (inner part)