Securing Longitudinal Member For Wheel Housing Upper Section (Inner Part)

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Apply adhesive on the joint area of the body.
Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm

>5X00IN WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding areas
Apply adhesive on the insides of the longitudinal member for wheel housing upper section [inner part).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding areas
1. 2.1 Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm
  Also apply an adhesive bead of sealant all around the bonding surface. > Application depth 3 mm
Rivet in [inner part of)longitudinal member for wheel housing upper section. > BLIND RIVET 999.190.227.01

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rivet area