Installing (Front) Roll-Over Bar Reinforcement At The Bottom

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Coat connection area on the (front) roll-over bar reinforcement at the bottom in the marked area with > ADHESIVE 000.043.206.30.
5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coating connection area on (front) roll-over bar reinforcement with adhesive
> ADHESIVE 000.043.206.30 must be applied to the prepared bonding area of the (front) roll-over bar reinforcement at the bottom in the marked areas.
5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Applying adhesive on (front) roll-over bar reinforcement at the bottom
Insert (front) roll-over bar reinforcement at the bottom and align it with the bores you have made.
Rivet in (front) roll-over bar reinforcement at the bottom -13- in areas J> - working from top to bottom - into the underbody using > BLIND RIVET 999.190.227.01 .
5X00IN83 CONNECTING ELEMENTS FOR BODY REPAIRS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Riveting in (front) roll-over bar reinforcement at the bottom
Install side clips, upper door strut and lower door strut and tighten screws.
69721920 Removing and installing roll-over bar