Preparing Rear Cross Member For Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Fit in new part and secure it to the body. Check gap dimensions.
5X00IN41 GAP DIMENSIONS - SECTION ON "PREPARING"
Prepare upper and lower part of rear cross member for bonding and welding.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparing rear cross member for installation

Yellow Bonding + resistance spot-welding