Installing Rear Cross Member

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Install rear cross member and check that it fits perfectly. Check gap dimensions.
5X00IN41 GAP DIMENSIONS - SECTION ON "INSTALLING"
Apply adhesive. > Application depth 3.0 mm
Working with body structural adhesive

5X00IN41 GAP DIMENSIONS - SECTION ON "INSTALLING"

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Applying adhesive

Yellow Bonding + resistance spot-welding
Resistance spot-weld the rear cross member

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installing rear cross member

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installing rear cross member