LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2022 >> 718 Boxster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (5X - Body General) >> WM, 5X00IN25 Making Ground Connections >> Making Ground Connection Using A Rivet Nut

Making Ground Connection Using A Rivet Nut

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drill a hole. > Diameter 4 mm 
    G14269701Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Drilling hole

  2. Remove dirt and primer using an end brush > 9399/3 - end brush  .
    G14269702Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing primer

  3. Drill out the bore. > Diameter 11 mm 
    G14269703Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Drilling out bore

  4. De-burr the bore on both sides.
  5. Fit and tighten blind rivet nut. > BLIND RIVET NUT 999.500.196.01  > V.A.G 1765C - Pop Rivet Nut Pliers 
    G14269704Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Tightening blind rivets

  6. Screw on components using a countersunk screw. > COUNTERSUNK SCREW 999.073.549.01 
  7. Tighten threaded joint to the specified torque. > Tightening torque 15 N.m (11 ft.lb) 
scientia non olet · About LEMON Manuals