Joining process
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Use foam filler within the processing time.
- Do not apply pressure on foam-filled parts until hardening is complete.
- Remove seal on the activation lid.
- Use a piece of wire to pull the activation lid out as far as it will go (approx. 11 cm up to the notch).
- Break off the wire at the required rupture point (notch) over the valve.
- Screw plastic adapter into the valve.
- Shake can vigorously up and down (approx. 20 times).
- Release foam downwards out of the can with the valve.