Working With Body Structural Foam: Hardening
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.
The body structural foam used hardens at temperatures of between > Minimum temperature 20°C and > Maximum temperature 50°C .
Hardening can be accelerated by applying heat (e.g. using an infrared heater or in a painting booth).
Information
Infrared heaters only heat small sections of the body and are therefore only suitable for minor repairs.
- Only use devices with temperature control, automatic distance measurement and measuring point display.
Do not put pressure on bonded parts until the required assembly strength is reached.