Spacer for replacing the vehicle identification number

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.

The spacer for applying the vehicle identification number is in the front right seat cross member. Two sections are intended for use.

Section 1 -A- is the standard spacer.

Section 2 -B- is the spare spacer for a corrected vehicle identification number.

Fig 1: Checking Front Right Seat Cross Member Length Dimension

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Vehicle identification number

X > Length 142 mm
Y > Length 22 mm
Z > Length 20 mm

Information

Only stamp the vehicle identification number on a cathodic dip-coated sheetmetal part.

Stamp the vehicle identification number to be replaced using > VAS 6939 - Steel stamping number set and the Porsche star > 9693 - Hand-held marking punch in the space provided for this purpose.
Mask imprinted vehicle identification number.
Paint using exterior paint.
Remove the vehicle identification number mark.
Paint repair area with clear lacquer.
¹⁾ Cathodic-dip coating is the primer applied to the sheetmetal parts at the factory