Preparing Body Front Section For Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Fit body front section and secure it to the body. Check gap dimensions.

5X00IN DIAGRAM - BODY GAP DIMENSIONS

Position body front section using the straightening system.

1.1 Drill bores for the rivets through the existing holes. > Diameter 6.6 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drilling holes in upper longitudinal member area

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drilling holes in wheel housing area

Drill through existing bore holes from inside the vehicle. > Diameter 6.6 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drilling holes in bulkhead area
Drill through existing bore holes from inside the vehicle. > Diameter 6.6 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drilling holes in side member area

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drilling holes in footwell area

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drilling holes in footwell area
Prepare connection areas on the body front section.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparing body front section