LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2022 >> 718 Boxster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (50 - Body Front) >> WM, 507955 Replacing Front Side Member (Section) >> Subsequent Work For Body Repairs (With Straightening System)

Subsequent Work For Body Repairs (With Straightening System)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release and remove vehicle from the straightening system.
  2. Clean joint areas and sheetmetal flanges with a wire brush.
  3. Prime joint areas and sheetmetal flanges with 2K primer.
  4. Restore standard seal with body sealant

    5X00IN42 SEAM SEALING - SECTION ON "INFORMATION"

    Also seal the repair area carefully.

  5. Paint repair area and adjacent surfaces, if necessary.
  6. Restore standard underbody protection with underbody sealant

    5X00IN43 UNDERBODY PROTECTION - SECTION ON "INFORMATION"

  7. Apply standard cavity preservation

    5X00IN44 CAVITY PRESERVATION - SECTION ON "INFORMATION"

    Also carefully apply cavity preservation to the repair area.

  8. Install removed accessories in the repair area.
scientia non olet · About LEMON Manuals