Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Observe warning notes.
> 2X00IN GENERAL WARNING NOTES FOR WORKING ON THE HIGH-VOLTAGE VEHICLE ELECTRICAL SYSTEM
Remove engine safety device.
> 1001IN SUPPORTING ENGINE ON THE BODY (ENGINE SAFETY DEVICE)
Install spring struts with front drive shafts
> Refer to the appropriate Service Information for Removing and installing front spring strut

> 433019 REMOVING AND INSTALLING FRONT AIR-SPRING STRUT
Install front-axle support.
> 400819 REMOVING AND INSTALLING FRONT-AXLE SUPPORT
Install wheel housing liners on both sides of the vehicle.
> WM, 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER
Install front wheels.
> WM, 440519 REMOVING AND FITTING WHEEL
Connect 12-volt battery.
> WM, 270619 REMOVING AND REINSTALLING BATTERY
1. 7.1 Read and follow work instructions after disconnecting the battery.
  > 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
Only for vehicles with PDCC: Start the 48 V system.
> 270703 DISCONNECTING AND STARTING 48 V SYSTEM
Start the high-voltage system and complete the relevant documentation.
> 2X00IN ISOLATING HIGH-VOLTAGE ELECTRICAL SYSTEM FROM POWER SUPPLY/STARTING HIGH-VOLTAGE ELECTRICAL SYSTEM
Bleed the cooling system.
> 193817 DRAINING AND FILLING COOLANT
Perform suspension alignment.
> 449503 PERFORMING FRONT AND REAR SUSPENSION ALIGNMENT