LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (20 Fuel Supply, Actuator 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 203819 Removing And Installing Supply Line >> Subsequent Work >> Subsequent Work (Section From Fuel Tank To Engine)

Subsequent Work (Section From Fuel Tank To Engine)

WARNING: This page is about a different variant/trim than selected.
  1. Install circulating pump for auxiliary heater.

    > Refer to the appropriate Service Information for Removing and installing circulating pump for auxiliary heater

  2. Install rear part of front wheel housing liner at the right.

    > WM, 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER

  3. Fit right front wheel.

    > WM, 440519 REMOVING AND FITTING WHEEL

  4. Install fuel tank.

    > 201019 REMOVING AND INSTALLING FUEL TANK 

    Subsequent work - V6 Turbo (section from engine to high-pressure pump) 

  1. Install heat shield.

    > WM, 261219 REMOVING AND INSTALLING HEAT SHIELD FOR TURBOCHARGER (V6 TURBO)

  2. Install cross panel.

    > WM, 508119 REMOVING AND INSTALLING CROSS PANEL

    Subsequent work - V8 biturbo (section from engine to high-pressure pumps) 

  1. Install exhaust system.

    > 260119 REMOVING AND INSTALLING EXHAUST SYSTEM

  2. Install cross panel.

    > WM, 508119 REMOVING AND INSTALLING CROSS PANEL

  3. Check coolant and bleed the cooling system.

    > 193817 DRAINING AND FILLING COOLANT (INCLUDES BLEEDING)

scientia non olet · About LEMON Manuals