LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> 911 Targa 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (17 - Engine - Lubrication 3.0L (Eng Code MDK.Kb) -- 992 - 911 CARRERA (992)) >> WM, 176719 Removing And Installing Oil Cooler Bracket >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2024 Porsche 911, 2023 Porsche 911, and 2022 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place protective covers on the vehicle.
  2. Lift the vehicle.

    > WM, 519419 REMOVING AND INSTALLING REAR COVER

  3. Remove rear underbody panelling.

    >  WM, 519419 REMOVING AND INSTALLING REAR COVER 

  4. Drain engine oil.

    170117 CHANGING ENGINE OIL AND OIL FILTER 

  5. Remove air cleaner housing.

    242519 REMOVING AND INSTALLING AIR CLEANER HOUSING

  6. Lower the engine with a jack.

    100109 LOWERING THE ENGINE

  7. Remove intake-air distributor for cylinder bank 4-6.

    244619 REMOVING AND INSTALLING INTAKE-AIR DISTRIBUTOR

  8. Disconnect the air-conditioning compressor and set it aside (do not open lines).

    >  WM, 873419 REMOVING AND INSTALLING AIR-CONDITIONING COMPRESSOR 

  9. Remove oil cooler.

    174019 REMOVING AND INSTALLING OIL COOLER (OIL-WATER HEAT EXCHANGER) 

  10. Remove oil separator.

    105519 REMOVING AND INSTALLING OIL SEPARATOR