Preparing Rear Jacking Point For Installation

De-burr contact surfaces on the body.
Position new rear jacking point -1- at -A- > Distance 57 mm and mark centre points.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position
Remove rear jacking point.
Drill holes for self-tapping screws using > Diameter 3.5 mm
> 5X00IN24 SETTING SELF-TAPPING SCREWS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Holes
Prepare the marked areas for bonding and fastening.
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding areas