Installing FLOORPAN

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Install floorpan and check that it fits perfectly
2. Remove floorpan.
3. Apply adhesive on joint areas of the body

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding points

4. Apply adhesive on joint areas of the body

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding points

5. Apply adhesive to the floorpan.

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Connection areas

6. Rivet in floorpan. > BLIND RIVET 999.190.227.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Floorpan

7. Rivet in floorpan. > BLIND RIVET 999.190.227.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bore holes for rivets, bottom

8. Set self-tapping screws.

   > 5X00IN24 SETTING SELF-TAPPING SCREWS

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Self-tapping screws

9. Set self-tapping screws.

   > 5X00IN24 SETTING SELF-TAPPING SCREWS

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Self-tapping screws