Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Engine mount bracket to cylinder head | Screw, M8 x 35 | Tightening torque | 33 Nm (24 ftlb.) | ||
| Engine mount bracket to cylinder head | Screw, M8 x 45 | Tightening torque | 33 Nm (24 ftlb.) | ||
| Engine mount bracket to cylinder head | Screw, M8 x 110 | Tightening torque | 33 Nm (24 ftlb.) | ||
| Engine mount bracket to cylinder head | Screw, M8 x 125 | Tightening torque | 33 Nm (24 ftlb.) | ||
| Heat shield for cylinder head 1-2 to cylinder head cover | Screw, M6 x 12 (10.9) | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Vacuum line to vacuum pump, cylinder head and cylinder head cover | M6 x 14 (10.9) | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Vacuum pump heat shield to cylinder head and vacuum line | M6 x 14 (10.9) | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Cylinder head cover to cylinder head | Internal Torx, M6 x 25 (10.9) - the first 4 screws must always be retightened | Tightening torque | 13 Nm (9.5 ftlb.) | ||
| Ground line to cylinder head cover (ignition coil) | Cheese head bolt, M6 x 12 (8.8) | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Exhaust gas temperature sensor holder to cylinder head cover | Screw, M6 x 12 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Control valve holder to cylinder head cover | M6 screw | Tightening torque | 13 Nm (9.5 ftlb.) | ||
| Ignition coil to cylinder head cover | Screw, M6 x 46 (integrated securely in ignition coil) | Tightening torque | 11 Nm (8 ftlb.) | ||
| Oil line for turbocharger | M6 x 12 | Tightening torque | 10 Nm (7.5 ftlb.) |