LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (28 Ignition System, PREGLOW System 2.0L -- 95B - MACAN (95B)) >> WM, 287319 Removing And Installing Pulse Sender (R4) >> Installing Pulse Sender

Installing Pulse Sender

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Check O-ring for damage and replace it if necessary.
    2. 1.2  Tighten screw on pulse sender.
      • Tightening torque 10 Nm (7.4 ftlb.)
scientia non olet · About LEMON Manuals