LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (28 Ignition System, PREGLOW System 2.0L -- 95B - MACAN (95B)) >> WM, 287219 Removing And Installing Knock Sensor (R4) >> Installing Knock Sensor

Installing Knock Sensor

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Move knock sensor into installation position.
    2. 1.2  Replace screw for knock sensor.
    3. 1.3  Tighten screw on knock sensor.
      • Initial tightening 8 Nm (6 ftlb.) 
      • Torque angle 90° 
scientia non olet · About LEMON Manuals