Installing Hall-Sender Rotor

Information 

• Check the new hall-sender rotor before installing it. 
• The hall-sender rotor must not come into contact with a magnet. 
• If the hall-sender rotor comes close to a magnet, replace it. 

Information 

Only install an undamaged hall-sender rotor.

Information 

Information 

The hall-sender rotor can only be installed at one position because the bores on the crankshaft are offset.

1. Install new  hall-sender rotor.
   1. 1.1  Position new  hall-sender rotor, making sure that the bores on the hall-sender rotor and crankshaft are aligned.
   2. 1.2  Screw in and tighten new  screws.
      • Initial tightening 10 Nm (7.5 ftlb.) 
      • Final tightening + 90°