Install Camshaft Sensor (Outlet Camshaft)
WARNING: This page is about a different variant/trim than selected.
Information
- O-rings must always be replaced.
- O-rings must be coated lightly with Kluber Syntheso Glep.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Replace O-ring on camshaft sensor for outlet camshafts.
- 1.2
Tighten screw on camshaft sensor for outlet camshaft.
- Tightening torque 9 Nm (6.6 ftlb.)