Installing B-Pillar For Convertible Top Frame

Information 

Complete assembly of the convertible top is performed on the vehicle.

1. Screw bracket for mount onto B-pillar for convertible top frame. > Tightening torque 9 N.m (6.5 ft lb.) +/- 1 N.m (0.5 ft lb.) 
2. Install B-pillar for convertible top frame.
   1. 2.1 Fit B-pillar for convertible top frame -2-  in the vehicle.
   2. 2.2 Guide on fastening screw -1-  for rear convertible top support. This will be tightened to the specified torque after the convertible top frame has been assembled

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Rear convertible top support

3. Install roll-over bar.

   > INSTALLING ROLL-OVER BAR - section on "Installing"

4. Secure front convertible top support.
   1. 4.1 Guide on fastening screws for front convertible top support -1-  . This will be tightened to the specified torque after the convertible top frame has been assembled

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Front convertible top support