Subsequent Work
NOTE:
Risk of damage to cover if excessive heat is applied.
- Creases in cover
→ If creases have formed, only short partial warming with the hot-air gun is permissible.
→ The hot-air temperature of 50°C must always be observed.
- If creases have formed, partially heat the affected areas of the cover with a hot-air blower > V.A.G 1416 - Hot-air blower
and smooth out the cover using the following special tools:
> 9747 - Wetting-off iron
> 9747/1 - Knurling tool
> 9747/2 - Bone burnisher
- Install control button for backrest adjustment at the left and right.
- Install backrest cover.
- Install cover for front middle backrest.
> 742019 REMOVING AND INSTALLING COVER FOR FRONT MIDDLE BACKREST
> 742019 REMOVING AND INSTALLING COVER FOR FRONT MIDDLE BACKREST (AIR-CONDITIONED COMFORT SEAT)
- Install front seat.