LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> 718 Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (42 Rear Wheel Suspension Drive Shaft 2.5L -- 982 - BOXSTER/CAYMAN) >> WM, 427119 Removing And Installing Rear Spring Strut >> Preliminary Work

Preliminary Work

WARNING: This page is about a different variant/trim than selected.
  1. Loosen axle nut (securing drive shaft to wheel bearing housing). Also apply the brake (2nd mechanic required) while the vehicle is stationary on the ground.
  2. Lift the vehicle.

    > 4X00IN LIFTING THE VEHICLE - article on "Lifting and lowering"

  3. Remove rear wheel.

    > 440519 REMOVING AND INSTALLING WHEEL - article on "Removing"

    For vehicles with PCCB brake discs, use assembly aids (two assembly pins).

  4. Remove covers over spring strut.

    Boxster:  Remove service covers in rear luggage compartment.

    > WM, 700619 - REMOVING AND INSTALLING REAR LUGGAGE COMPARTMENT TRIM PANEL

    G14948013Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unclipping service covers

    Boxster Spyder:  Remove rear luggage-compartment lining

    > WM, 700619 - REMOVING AND INSTALLING REAR LUGGAGE COMPARTMENT TRIM PANEL

    Cayman:  Remove rear covers -1-  .

    > Refer to the appropriate Service Information for Removing and installing rear cover

    G14948014Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Rear cover

    Remove cover over spring-strut mount -1-  .

    G14948015Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing cover over spring-strut mount