LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> 718 Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (48 Steering 2.5L -- 982 - BOXSTER/CAYMAN) >> WM, 489055 Replacing Power-Steering Gear >> Subsequent Work

Subsequent Work

WARNING: This page is about a different variant/trim than selected.
  1. Install front-axle support

    > 400819 REMOVING AND INSTALLING FRONT-AXLE SUPPORT

  2. Install front underbody panelling

    > WM, 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY

  3. Install front wheels

    > 440519 REMOVING AND INSTALLING WHEEL .

  4. If the power-steering gear was replaced:  Code the power-steering gear using > 9818 - PIWIS Tester II (automatic data adaptation).
  5. Check the front toe and make adjustments if necessary

    > 449503 SUSPENSION ALIGNMENT, COMPLETE

  6. Calibrate steering-angle sensor

    > 456005 INITIALIZING AND CALIBRATING PSM STEERING-ANGLE SENSOR

  7. Re-teach steering lock settings for the power-steering gear

    > 489025 PROGRAMMING POWER-STEERING GEAR 

scientia non olet · About LEMON Manuals