Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Install bellows for steering-gear housing
> 485319 REMOVING AND INSTALLING BELLOWS STEERING-GEAR HOUSING
- Install tie-rod ball
> 488119 REMOVING AND INSTALLING TIE-ROD BALL (TIE-ROD END) - article on "Removing"
- Install front underbody cover.
> WM, 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY
- Fit wheel.
> 440519 REMOVING AND INSTALLING WHEEL - article on "Installing"
- Check the front toe and make adjustments if necessary
- Calibrate steering-angle sensor
> 456005 INITIALIZING AND CALIBRATING PSM STEERING-ANGLE SENSOR
- Re-teach steering lock settings for the power-steering gear