Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Fit clutch slave cylinder on the transmission.
> 303019 REMOVING AND INSTALLING CLUTCH SLAVE CYLINDER
Install both transmission mounts.
> 374019 REMOVING AND INSTALLING TRANSMISSION MOUNT
Tighten left and right drive shaft on the transmission.
> 422119 REMOVING AND INSTALLING DRIVE SHAFT
Install rear-axle cross member.
> 420619 REMOVING AND INSTALLING REAR-AXLE CROSS MEMBER
Secure the shift and selector cables on the transmission.
> 341219 REMOVING AND INSTALLING SHIFT AND SELECTOR CABLES
Install rear anti-roll bar.
> 429019 REMOVING AND INSTALLING REAR ANTI-ROLL BAR
Install exhaust system.
> 260119 REMOVING AND INSTALLING EXHAUST SYSTEM
Fit rear wheels.
> 440519 REMOVING AND INSTALLING WHEEL
Connect the battery.
> 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
Fill in coolant and bleed the system.
> WM, 190107 - BLEEDING THE COOLING SYSTEM