Filling Device - Overview And Setup
WARNING: This page is about a different variant/trim than selected.
Components of vacuum-filling device
| 2 | Hose extension FZ 100 (install between K65 and KVB 01) |
| 3 | KVB 01 (Vacuum gauge with two shut-off valves) > 9696 - Filling device |
| 4 | Venturi nozzle for creating a vacuum. A minimum pressure of 8 bar must be available. |
| 5 | Filler hose (The cooling system is refilled via this hose) |
| 6 | Return lines (The compressed air and extracted coolant are drawn off via this hose) |
| V1 | Shut-off valve V1 (Shut-off valve for filler hose) |
| -V2- | Shut-off valve V2 (Shut-off valve for filler hose - outlet to Venturi nozzle) |
Illustration of vacuum-filling device setup
| 1 | Return lines |
| 2 | Overflow container (bucket or canister) |
| 3 | Compressed air connection |
| 4 | Make sure the compressed air connection has a minimum pressure of 8 bar. |
| 5 | Filling canister with coolant (Position at the same height as the reservoir to make filling easier) |
| 6 | Fit adapter K 65 with extension FZ 100 instead of the cap. |
| 7 | KVB 01 (Vacuum gauge with two shut-off valves V1 and V2) |
| V1 | Shut-off valve V1 (Shut-off valve for filler hose) |
| -V2- | Shut-off valve V2 (Shut-off valve for filler hose - outlet to Venturi nozzle.) |