Subsequent Work

1. Install side member reinforcement. Refer to 514955 REPLACING SIDE MEMBER REINFORCEMENT .

Subsequent work for body repairs (without straightening system) 

1. Clean joint areas and sheetmetal flanges with a wire brush.
2. Prime joint areas and sheetmetal flanges with 2K primer.
3. Restore standard seal with body sealant. Refer to WM 5X00IN SEAM SEALS .

   Also seal the repair area carefully.

4. Paint repair area and adjacent surfaces, if necessary.
5. Restore standard underbody protection with underbody sealant. Refer to WM 5X00IN UNDERBODY PROTECTION .
6. Apply standard cavity preservation. Refer to WM 5X00IN CAVITY PRESERVATION . Also apply cavity preservation to the repair area.
7. Install removed accessories in the repair area.

Model year as of 2014