Installing Rubber Mounting For Rear Final Drive, Output Side

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rubber mounting for output side

Information 

Noises in drive train.

• Installation position of rubber mounting bulge is incorrect. Rubber mounting bulge must be installed vertically into the housing. 
• Installation position of mounting in housing is incorrect. Check installation dimension of mounting with respect to the housing. 

1. Check installation position of rubber mounting. The large cut-outs -arrows-  on the rubber mounting must be perpendicular -1-  to the real-wheel drive assembly.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Installation position of rubber mounting

2. Press rubber mounting into the housing until flush using special tool.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rubber mounting for output side