Packing Lithium-Ion Module With Module Status "Normal" (Not Critical)
WARNING: This page is about a different variant/trim than selected.
WARNING:
Incorrect handling of high-voltage components
- Electric shock
- Short circuit
- Fire
- Explosion
→ Only appropriately trained and authorized persons may work on high-voltage vehicles and components.
→ Required qualification: High voltage technician or high voltage expert.
→ Observe national requirements and legislation for this work.
→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.
→ Observe general warning notices for working on the high-voltage system.
→ > 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM
Information
The original test log for classification of the lithium-ion module must be kept in the Porsche Centre.
- Place lithium-ion module in the transport box in which the new lithium-ion module was supplied by Porsche AG.
The supplied impact protection in the transport box must be fitted fully around the lithium-ion module.
- Put a copy of the test log for classification of the lithium-ion module in the transport box.
- Close the transport box.
- Affix the following labels on one long side of the transport box:
- "Hazardous goods class 9" label
- "UN 3480, lithium ion batteries" label
- "Item number (small)" label
- Document bag
- Complete accompanying documentation and place it in the document bag together with another copy of the test log for classification of the lithium-ion module.
- Affix "Item number (large)" label on one short side of the transport box.