Installing Rotor Position Sensor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Incorrect handling of high-voltage components

Electric shock
Short circuit
Fire
Explosion
→ Only appropriately trained and authorized persons may work on high-voltage vehicles and components.

→ Required qualification: High voltage technician or high voltage expert.

→ Observe national requirements and legislation for this work.

→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.

→ Observe general warning notices for working on the high-voltage system.

> 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM

Replace gasket -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Seal
Fit rotor position sensor -3- and tighten new screws -2- evenly with > Tightening torque 7 Nm (5.2 ftlb.) .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rotor position sensor
1. 2.1 Connect and lock electric plug connection for rotor position sensor -1- .
  The electric plug connection must engage perceptibly.
Only V6 Hybrid: Position heat shield -2- and fit and tighten screws -1- .
> Tightening torque 8 Nm (6 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Only V6 Hybrid heat shield for rotor position sensor
1. 3.1 For vehicles with particle filter: Fit and tighten screw -3- .
>