Preparing bonding surfaces: Hardening
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
The body structural foam used hardens at temperatures of between → Minimum temperature: 20°C and → Maximum temperature: 50°C .
Information
Infrared heaters only heat small sections of the body and are therefore only suitable for minor repairs.
- Only use devices with temperature control, automatic distance measurement and measuring point display .
Hardening can be accelerated by applying heat (e.g. using an infrared heater or in a painting booth).
Do not put pressure on bonded parts until the required assembly strength is reached.