Joining process

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Use foam filler within the processing time .
Do not apply pressure on foam-filled parts until hardening is complete .

Remove seal on the activation lid.
Use a piece of wire to pull the activation lid out as far as it will go (approx. 11 cm up to the notch).
Break off the wire at the required rupture point (notch) over the valve.
Screw plastic adapter into the valve.
Shake can vigorously up and down (approx. 20 times).
Release foam downwards out of the can with the valve.