Calibrating hydraulic unit/control unit

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Always read the information. → 453055 REPLACING HYDRAULIC UNIT/CONTROL UNIT

If the hydraulic unit is replaced, the control unit of the hydraulic unit must be coded and calibrated .

Calibrate the combination sensor (includes lateral and axial acceleration sensor and yaw rate sensor) using PIWIS Tester II 9818 .
To do this, select:

> Control unit overview

> PSM

> Drive links/checks

> Calibration of combination sensor

This completes the calibration process.