Installing lock peg
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Some of the repair illustrations show only one side of the vehicle or a similar component .
- Naturally, some steps also have to be performed on the opposite side of the vehicle as well .
- Position lock peg and screw in the fastening screws. Locking clip - bend facing inside of vehicle.
- Carefully close vehicle door and check that the lock peg is correctly positioned with respect to the lock.
- Adjust the lock peg to suit the lock as required.
- Tighten fastening screws to Tightening torque 25 Nm (19 ft lb.) until secure.
- Check adjustment of vehicle door and adjust it if necessary. → 585115 ADJUSTING REAR DOOR - "ADJUSTING"