Installing Inner Side Member

Install inner side member and check that it fits perfectly. Check gap dimensions. → WM 5X00IN GAP DIMENSIONS

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive .
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed .
Do not begin bonding work until all materials and tools necessary for later repair work are available .

1.1. Apply adhesive to the marked areas. → 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE → Application depth: 3.0 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Resistance spot-weld the inner side member.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Plug-weld area -A- using inert gas.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.