Removing Engine Cover (Design Cover): Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

For easier access to components, use the tool > 9824 - flexible-head socket wrench together with > 9824/2 - Torx Micro Bit if necessary.

Remove fastening screws on the design cover at the ignition coils -3- .

Lift up the torque support on the valve cover. Pull the design cover up off the fastening points.

Fig 1: Design Cover On Engine Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Design cover on engine

1	Design cover on cylinder bank 1
2	Design cover on cylinder bank 2
3	Screw; design cover to ignition coil
4	Fastening points (ball joints)

Remove design cover on throttle valve.

Pull design cover off the throttle valve > Design cover on throttle valve .

Fig 2: Design Cover On Throttle Valve Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Design cover on throttle valve

1	Design cover on throttle valve (view from above)
2	Design cover on throttle valve (side view)
3	Ball joints under design cover
4	Bonding area, Velcro fastener