Installing Engine Cover (Design Cover): Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
The tightening specifications for the basic engine are stored centrally.
/
or
> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS
Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.
- Lift up the torque support at the cylinder head cover. Move cover into installation position and press on the ball joints on the valve cover.
- Fit fastening screws on the cover at the ignition coils.
Design cover on engine
1 Design cover on cylinder bank 1 2 Design cover on cylinder bank 2 3 Screw; design cover to ignition coil 4 Fastening points (ball joints) - Fit design cover for throttle valve.
Fit design cover over the throttle valve and press on the Velcro strip > Design cover on throttle valve .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Design cover on throttle valve
1 Design cover on throttle valve (view from above) 2 Design cover on throttle valve (side view) 3 Ball joints under design cover 4 Bonding area, Velcro fastener