LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 795 (10 - Engine - Crankcase, Suspension 4.8L Turbo -- 970 - PANAMERA (970)) >> WM, 103719 Removing And Installing Torque Support >> Removing Torque Support

Removing Torque Support

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the two screws and nuts on the body and valve cover.
  2. Remove torque support.
    Fig 1: Torque Support Components Location
    G15197891Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Installation position of torque support

1  Aluminium screw, M10
2  M10 nut; counter when using tools.
3  Bracket on valve cover
4  Bracket on body
5  Torque support part identification on the back, must be installed in opposite direction to direction of travel.
scientia non olet · About LEMON Manuals