Installing Left Engine Mount

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

The tightening specifications for the basic engine are stored centrally.

> TECHNICAL VALUES

> WM 2X00IN TECHNICAL VALUES (PANAMERA, PANAMERA S, PANAMERA S EXECUTIVE, PANAMERA 4, PANAMERA 4S, PANAMERA 4 S EXECUTIVE)

> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS

Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

Guide engine mount into the mounting provided for it.
Guide the engine mount guide pin into the groove provided for it -arrow- so that it can no longer pop out.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Guide pin
Press against the engine mount from below -arrow- and tighten the fastening nuts on the engine mount > Nr.89 Pos.3 - Connecting piece .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Securing engine mount (figure shows 4WD turbo engine)
Place heat shield in installation position. Fit and tighten four fastening screws -arrows- for the heat shield.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws on heat shield (illustration shows removed primary catalytic converter, but left primary catalytic converter remains fitted)