Securing Engine On Assembly Support
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Heavy components
- Risk of squashing
- Wear personal protective gear.
- Get someone to help if necessary.
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
- Secure components to prevent them from falling down.
Information
- The engine needs to be suspended on an assembly support for certain repair work.
Information
- A modified engine support is used for the Panamera because of the Start/Stop starter and the all-wheel drive engine 4 WD.
- The turbo engine, including the flywheel and front-axle final drive, weighs about 290 kg. To avoid overloading the engine support, make sure that there are no additional loads (e.g. heavy components stored in the vehicle or a person sitting in the vehicle).
- Secure engine support > 9676/1 - engine support
to the engine. To do this, use the four screws > 9590 - mounting parts
and tighten them. > Engine support
Bend the heat protection panel on the front-axle final drive on the turbo engine aside slightly if necessary (collision).
Engine support
- Move engine in front of the engine support (assembly support) using the workshop crane and guide it in with the help of a second worker. Lift the engine so that it can be eased in horizontally. > Engine crane and engine on assembly support
Engine crane and engine on assembly support
- Secure engine on assembly support. > Engine secured on assembly support
Engine secured on assembly support