Subsequent Work
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Following replacement of the high-pressure pump and engine, the values for the high-pressure adaptation must be reset using the PI WIS Tester. Then carry out a test and adaptation drive. Read the information in the portion
- The current software must be installed on the control unit if necessary. Following conversion to a new engine, it is possible that an old software version may still be installed on the control unit.
- Install front left wheel housing liner completely on vehicles with PDCC.
- Install front part of front wheel housing liner on both sides.
- Fasten brake calliper on both sides.
> WM 473919 REMOVING AND INSTALLING FRONT BRAKE CALLIPER (ALL MODELS)
> WM 473919 REMOVING AND INSTALLING FRONT BRAKE CALLIPER (PCCB) (ALL MODELS)
- Install cardan shaft.
- Install exhaust system.
- Install underbody panelling.
- Install rear profile seal.
- Install plenum panel cover.
- Install cowl panel covering.
- Connect battery ground strap.
> 9X00IN Work instructions after disconnecting the battery. Refer to appropriate procedure in 9X - ELECTRICAL SYSTEM - GENERAL -- PANAMERA (970)
- Fill up coolant.
- Fill up refrigerant for the air conditioning system.
- Fill the hydraulic oil tank.
> Refer to 489755 Replacing reservoir
- Bleed the power steering.
- Check ATF level.
> WM 370235 CHECKING AND TOPPING UP ATF (PANAMERA S E-HYBRID, PANAMERA S HYBRID)
- Check engine-oil level.
- Perform suspension alignment.
> 449503 Suspension alignment, complete. Refer to appropriate information in 44 - WHEELS, TIRES, SUSPENSION ALIGNMENT -- PANAMERA (970)
- Adjust the locking cable.
- Perform a test drive.
After the cooling system has cooled down, check the engine coolant level in the reservoir and top up to the max. mark if necessary.