LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (42 - Rear Wheel Suspension, Drive Shafts -- PANAMERA (970)) >> WM 420519 Removing And Installing Rear Axle Housing (Chassis SUBFRAME) (Except PANAMERA GTS, PANAMERA Turbo S, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit cardan shaft. → Installing Rear Cardan Shaft
  2. Fit exhaust system. → Installation Dimensions Of Exhaust System
  3. Bleed the air springs on vehicles with air suspension. → 4301IN BLEEDING AND FILLING THE LEVELLING SYSTEM
  4. Fit the steel springs on vehicles with steel suspension. → Installing Coil Spring 
  5. Bleed the PDCC system on vehicles with PDCC. → 430307 BLEEDING PORSCHE DYNAMIC CHASSIS CONTROL (PDCC)
  6. Install rear left wheel housing liner. → 536919 REMOVING AND INSTALLING REAR WHEEL HOUSING LINER
  7. Fit underbody panelling. → 519319 REMOVING AND INSTALLING COVER FOR CENTRE UNDERBODY → 519419 REMOVING AND INSTALLING COVER FOR REAR UNDERBODY
  8. Fit rear wheels. → 440519 REMOVING AND INSTALLING WHEEL
  9. Press the brake pedal if necessary in order to position the pads.
  10. Read out and erase the fault memory using PIWIS Tester II 9818  .
  11. Perform suspension alignment. → 449503 SUSPENSION ALIGNMENT, COMPLETE
scientia non olet · About LEMON Manuals