Technical values -60- Sliding roof, slide/tilt sunroof

TORQUE SPECIFICATION

Location	Description	Type	Basic value
Glass sliding roof motor to glass sliding roof frame	Internal Torx screw, M5 x 28, replace	Tightening torque	2 Nm (1.5 ft. lb.)
Sun blind motor to glass sliding roof frame	Internal Torx screw, M5 x 28, replace	Tightening torque	2 Nm (1.5 ft. lb.)
Fastening screw for bracket		Tightening torque	8 Nm (6 ft. lb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fastening screws for roof assembly	Observe specified tightening sequence	Tightening torque	8 Nm (6 ft. lb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Securing roof assembly to body		Diameter	10 mm
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fastening screw for sliding-roof panel		Tightening torque	7 Nm (5 ft. lb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fastening screw for rear sliding-roof panel		Tightening torque	7 Nm (5 ft. lb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fastening screw for roll-up sunblind		Tightening torque	2.5 Nm (1.75 ft. lb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.