Installing The Antenna Leads In The Left Rear Spoiler Up To The Connection Point
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- 1 - Auxiliary heater receiver
- 2 - Right antenna amplifier control unit
- 3 - GPS antenna/receiver for the digital radio
- 4 - Left antenna amplifier
- 5 - Telephone antenna
- 6 - Auxiliary heater antenna
- X - Connection point for antenna leads in left rear spoiler
Information
- When installing the wire harness, make sure the insulation of the line is not damaged.
Information
- The line must run over the pneumatic spring for the rear lid.
- Push the wire harness along the left hinge into the passenger compartment and to the rear spoiler -arrows A- .
- Pull out the wire harness through the body, roof frame opening -arrow A- downward -arrow B- . If necessary, push lead from the outside.
- Coat the rubber sleeve with soap suds and pull in -arrow A- , until this is felt to engage in the opening -arrow B- .
- Push on the receiver antenna connector for the auxiliary heater -arrow A- , until the connector -arrow B- is felt to engage.
- Push on the receiver connector for the auxiliary heater -arrow C- , until the connector -arrow D- is felt to engage.
- Screw down the receiver for the auxiliary heater using the fastening screws -1-
.
Information
- The number of antenna connectors can vary, depending on the vehicle equipment.
- Push the connectors of the antenna leads in the sockets of the same colour -arrows A- until the connectors -arrow B- are felt to engage.
- Press the plug connections for the antenna leads into the brackets -arrows C- until the lugs -arrows D- are felt to engage.
- Insert the socket into the support for the socket -arrow A- , until the connectors -arrows B- are felt to engage.
- Insert the lines for the left rear spoiler into the support for the socket -arrow C- .
- Close the support -arrow D- until the locking tab -arrow E- is felt to engage.
- Press in support for socket -arrow A- until locking tabs -arrows B- are felt to engage.
- Screw down both ground straps together with torsion protection -a- to ground pin with fastening nut -1- . → Tightening torque: 9 Nm (6.5 ftlb.)
- Insert the connector to the rear left roof frame, until the connectors are felt to engage.
- Insert the antenna leads in both holders -arrow A-
- Connect together the plug connection on the hose for the spray nozzle -arrows B- and clip onto the roof frame -arrows C- .
- Coat the rubber sleeve with soap suds and press into the rear spoiler -arrow A- .
- Position wire harness in rear spoiler and press onto Velcro strip sections to secure -arrow B-
.
Information
- On vehicles up to model year 2004 the water line for the rear window washer is located in the right antenna lead set.
- On vehicles as of model year 2005 the water line for the rear window washer is located in the left antenna lead set.
- Push the water line onto the spray nozzle.
- Connect the connector for the telephone antenna to the line -arrow A- , until the lugs of the telephone antenna fuse -arrows B- are felt to engage.
- Install the left antenna amplifier. → Installing Antenna Amplifier
- Route the antenna for the auxiliary heater and press onto the Velcro strip section.
- Install GPS antenna. → Installing GPS Antenna
- Insert the retaining bracket and screw down both ground straps with the fastening nuts -arrow A- and the fastening screw -arrow B - .
- Push the wire harness under the right wire harness and connect the white connector to the white connection of the right antenna amplifier -arrow C - .
- Push both connectors onto the sockets of the same colour of the right antenna amplifier -arrow D - , until the lugs are felt to engage.
- Fasten the lines with a new tie-wrap -1- and secure with new adhesive tape -arrow E - .
- Insert the wire harness of the left rear spoiler into the wiring duct and press on the cover -arrow A- , until the lugs -arrows B- are felt to engage.
- Push wiring duct onto left hinge -arrow C - until locking tabs -arrow D - are felt to engage.
- Clip in left hinge cover.