LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (97 - Cables) >> WM 979019 Removing And Installing Relay Carrier, Plenum Chamber E-Box (All Models) >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat frame) is avoided. → WM 9000IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY (ALL MODELS)
  2. Place bonnet in service position.
  3. Remove wiper arms. → Removing Wiper Arms
  4. Remove cowl panel cover. → Removing cowl panel cover
  5. Remove left and rear trim panels in engine compartment. → Removing front trim (engine compartment)
  6. Remove radiator tank at front left.