LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 257 (69 Occupant Protection/Personal Protection -- 92A Cayenne) >> WM 691119 Removing And Installing Front Three-Point Belt >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install B-pillar trim panel. → INSTALLING B-PILLAR TRIM PANEL - section on "Installing"
  2. Connect the battery. → CONNECTING THE BATTERY
  3. Carry out a function test.
    • The belt strap must be fully rolled up when the function test is started.
    • Move the seat-belt height adjustment to the highest position.
    • Pull out the belt strap completely as far as it will go.
    • Roll up the belt strap again slowly. An audible buzzing noise can be heard when you do this.
    • If the roll-up process is interrupted, the belt strap cannot be pulled out again (permanent belt blockage).
    • The permanent belt blockage function must switch off at least 100 mm before the belt strap is rolled up fully, thereby ensuring that the belt strap can be pulled out again.
scientia non olet · About LEMON Manuals