Subsequent Work

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fit joint flange and cable plug for oil pressure control valve.
Fit ATF lines on the oil guide housing.
> 386219 Removing and installing line for ATF cooling - "INSTALLING "
Fit the oil pan.
> 175019 Removing and installing oil pan - "INSTALLING "
Fit the oil level sensor, plug in electric plug connection for the oil level sensor and route the cable.

On turbo engines, fit the two side oil extraction lines -5- and (bottom illustration) -8- on the oil guide housing.

Fig 1: Oil Circuit For Turbocharger Components Location - Cylinders 1 To 4

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Oil circuit for turbocharger, cylinders 1 to 4

1	Vent line for turbocharger, cylinders 1 to 4; vent line to oil extraction line for turbocharger
2	Oil feed line for turbocharger, cylinders 1 to 4; oil feed line for turbocharger to connection piece
3	Connection piece
4	Sealing ring
5	Oil extraction line
6	Screw, M6 x 12
7	Screw, M6 x 16
8	Seal for turbocharger, cylinders 1 to 4

Fig 2: Oil Circuit For Turbocharger Components Location - Cylinders 5 To 8

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Oil circuit for turbocharger, cylinders 5 to 8

1	Oil feed line for turbocharger, cylinders 5 to 8
2	M6 nut
3	Holding clamp
4	Vent line for turbocharger, cylinders 5 to 8
5	Holding clamp
6	Screw, M6 x 12; holder for turbocharger oil feed line to lower part of crankcase; holding clamp for oil feed line to holder
7	Screw, M6 x 16
8	Oil extraction line
9	Seal for turbocharger, cylinders 5 to 8
10	Sealing ring
11	Connection piece
12	Clamp
13	Holder for oil feed line

Install engine carrier.

> 103019 Removing and installing engine carrier - "INSTALLING "

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Engine carrier

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Complete front axle

1	Front-axle final drive
2	Front axle
3	Steering gear

For PDCC: Fit fastening nuts -1- securing front wire assembly -2- to the oil pan.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Line bracket for PDCC lines
Connect coolant supply line to the oil/water heat exchanger. Connect the coolant hoses to the oil/water heat exchanger at the same time. Remove hose clamps.
Clip in coolant hoses on the oil/water heat exchanger. > Coolant return line

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant return line
Fit vibration balancer.
> 137619 Removing and installing vibration damper (crankshaft pulley) - "INSTALLING "
Install engine guard.
> 108019 Removing and installing engine guard - "INSTALLING "
Fill in engine oil. For details, see > 170117 CHANGING ENGINE OIL AND OIL FILTER .
Bleed and fill the cooling system.
> 193817 DRAINING AND FILLING COOLANT (INCLUDES BLEEDING)
Align the front axle and bleed all open systems.
Carry out a check. After test-driving the vehicle, check the engine for leaks. Then check the oil level.